Epoxy syringe 5 min’ 24ml

PROPERTIES
Fast
Crystal clear
Super-strong
Universal, suitable for many materials
Resistant to temperatures between -40 °C and +100 °C
Filling
Water resistant
Chemical resistant
Paintable

SUITABLE FOR:
Suitable for fast, strong and invisible repair of many materials, such as pottery, porcelain, glass, leather, wood, stone, metal, ceramics. Both with themselves and in combination.

NOT SUITABLE FOR:
Not suitable for Polyethylene (PE), polypropylene (PP), PTFE and silicone rubber.

BEFORE USE:
Working conditions
Recommended application at temperatures between +10 °C and +35 °C. Product cures by mixing the resin and hardener.

Personal safety:
Preferably wear gloves.

Surface requirements:
The surface must be dry, clean and free of dust and grease.

Preliminary surface treatment:
Degrease parts to be bonded with denatured alcohol. Roughen smooth surfaces (sandpaper).

Tools:
Clean tools immediately after use with warm water and soap.

Mixture ratio:
1:1

Coverage:
1 ml = approx 10 cm² at a film thickness of 1 mm

DURING USE:
Handling of packaging
Remove the spatula from the side of the double syringe, and the closure cap from the handle. Break the seal of the double syringe.

Directions for use:
Inject both components in equal volume quantities in the mixing bowl. Next, mix the adhesive thoroughly with the supplied spatula until a homogenous mass is obtained. The mixture can, at room temperature (20 °C), be processed for about 5 minutes. Apply adhesive immediately after mixing on both parts. Join parts immediately and press firmly. The functional strength is reached after 20 min, final bonding strength after 12 h (both at room temperature).

Advice:
Some types of synthetics can not be joined such as polyethylene and polypropylene. Use a piece of adhesive tape in order to keep the parts in place while the adhesive is curing.

Points of attention:
After use close well (note: always place back the cap in the same way, due to the bonding of the cap to the double syringe). For optimum performance it is important to create a larger amount of adhesive and mix it very well. Curing time depends on the temperature. Adhesive does not cure below +5 °C.

AFTER USE:
Stains/residue:
Remove wet stains immediately with warm water and soap. Cured adhesive residue can only be removed mechanically.

Storage conditions:
Store in tightly closed packaging in a dry, cool and frost-free place.